19001 dimension drawings don't include 2.5mm header placement

WisBlock
1

I want to build a backplane PCB so I can plug the RAK 19001 into it via the 2.5mm header pins.

I have searched the docs and github content but can’t find the exact layout position of these headers on the board. There are photos which show position of mounting holes and other important parts, but they don’t include position of the 2.5mm header holes. While I can measure this by hand, it would be helpful to show on documentation to ensure accuracy. If I am missing something obvious, please point out.

As an aside: when clicking on the above anchor links to the documentation, it loads the incorrect section of the page. For example, the 2nd link points to #board-dimensions anchor, but when clicking it, you get #specifications, which then redirects to #hardware.

Thanks!

2

No guarantee, measured from RAK19001 Ver.B 3D file:

image
image833×707 22.3 KB

Not sure what you mean with the links. Working for me, but the Documentation Center is sometimes slow with loading images and even the original jump was correct, when loading images, it shows a different location.

1 Like