AT command to send Lat/Long

Issue: AT command to collect Lat/Long and send it thru TCP/UDP

Setup: WisTrio RAK5010 V2.0

Details:
I would like to know if is there a way “out-of-box” to collect GPS/GNSS location from BG96 module and send it to RAK5010 firmware AT command. But I mean one single command, like AT+send=XXX

Best Regards,

Jose Damico

Welcome to RAK forum @damico ,

There is a way to send the GPS data automatically via AT Command.

AT command for RAK5010 is here - RAK5010 AT Command Manual | RAKwireless Documentation Center

You can find the quick start guide there as well.

You just need to put the endpoint IP address and port.