LX200V50 Connection problems

WisLink
1

Hello, I have LX200v50 and I can’t set up communication, I’m sending photos of module connections and powered modules themselves, I would like to know if the LED responsible for the PLC should be lit constantly even when the PLC line is not connected

318221763_700846258015560_4554381753856673832_n
318221763_700846258015560_4554381753856673832_n1536×2048 627 KB

2

318282442_1463740677491011_7421449181671752049_n
318282442_1463740677491011_7421449181671752049_n2048×1536 321 KB

3

318674442_524251586386416_581676073270931904_n
318674442_524251586386416_581676073270931904_n2048×1536 306 KB

4

Hi there,

I have been having the same issue: I cannot get any communication between two V50 modules using the provided cable. Here is a photo of the setup:

IMG_0387
IMG_03871920×1440 308 KB

Any suggestions what could be the cause?

Regards,
Boris

5

Hi, @borkoyan can you send me your order number by e-mail([email protected]) or PM me here?

6

Hi Todor!

I don’t have the order number as they were ordered by a colleague who does not work for the company anymore.

The order was made by Borja Serra ([email protected]) for Blueye Roborics in Aug 2022. I hope this information is sufficient.

Kind regards,
Boris