RAK4630 + RAK12500

Issue: connection

Setup:

Server:

Details: Hi, im looking to make a simple single board using the rak4630 and zoe ublox chip and was just wanting to clarify if GPS stand-by goes to P0.10nfc2 as i see standby and reset goes to IO6 on the 12500 datasheet and only see IO6_NFC2 on rak4630. Is this correct? i would like to keep the pin layout the same so i can use the existing pin mapping in firmware.

Welcome to RAK forum @Binky ,

That is correct.

P0.10 is connected to IO6.

Here’s the layout of RAK4630 to RAK4631 board where it is connected to IO6 of WisBlock system.