RAK7268V2 Configuration

Hello, I’m new here so I’m just starting with the configuration of the gateway. The question is pretty basic but I can’t seem to figure it out.

I properly connected the antenna and powered the device using 12V DC. After some time, the SSID of RAK7268V2_XXXX appears. When I try to connect, I am unable to open the WEB management page then the following appears:

I hope you can help me figure this out

Welcome to RAK forum @wiljonherondale ,

I think there was a mistake on one digit. 190 should be 192.

It should be like this -

Hello, this is now resolved but the issue is the firewall. Thank you.