Reassemble Enclosure heat sync

Issue:
Hi everyone, I have had a 7240 gateway come crashing down in a storm a few months ago. It was damaged and I had to remove the back plate to straighten out. Amazingly when connected, it works just fine, and is testament to how well these things are built.
My question is, when I removed the backing plate, I’m unsure of the exact positioning of the heat sync plates? I have ordered thermal paste, but if anyone has photos of where to place them exactly that would be great…here are some screenshots of the damage etc…

image
image


image
image
image

Hello @Andy,
Wow, that was a whole crash test for the device :smiley: .

Thermal paste should be here:
image

As for the heat sink plates, I suggest you take them off the backside of the gateway and put them on their place (you should hear a quiet clicking when it does fit on the concentrator), and then close the gateway.

Best Regards

Ok, thanks @Nikola, I’ll check it out.